For:
Software update version 210414 VITA vPad excellence from serial number 2820170050
Software update version 210414 VITA vPad comfort from serial number 3020180051

VITA Zahnfabrik provides serial number-dependent software updates for model ranges of the devices mentioned above.

For this reason, you should check your serial number directly on the system before performing a software update.

Please only perform the software update if the serial number of your vPad is within the indicated range.

Content of software update 210414 for VITA vPad excellence from serial number 2820170050
• Values for the silver sample can also be adjusted in the active "VITA" profile.
• It is not possible to press the "Start" button again once the firing program has begun.
• Reduced the time it takes to edit log data at the start of firing
• Firing programs for KATANA added.
• For one-stage or two-stage firing programs, cooling is preset to 500°C at a 75% lift position.
• Press and hold the On / Off button to turn off all furnaces that are not firing.
• The lift button must be pressed longer to fully open and close.
• The introductory video can be played in the "Help" menu item.
• Firing programs for LUMEX added. • During pre-drying, the lift position is only displayed if the holding time is > 0.
• Older PDF changes are no longer contained in the updates.

Content of software update 210414 for VITA vPad comfort from serial number 3020180051
• Sintering program "YZ One for all" added.
• Lift positions in default programs adjusted.
• Firing programs for KATANA added. • For one-stage or two-stage firing programs, cooling is preset to 500°C at a 75% lift position.
• Firing programs for LUMEX added.
• During pre-drying, the lift position is only displayed if the holding time is > 0.
• Older PDF changes are no longer contained in the updates.

Content of software update 210414 for VITA ZYRCOMAT 6000 MS:
• Operational safety increased

Content of software update 210414 for VITA ZYRCOMAT 6100 MS:
• Operational safety increased • Operating values from the power supply unit (TDK) are stored in process data

Content of software update 210414 for VITA SMART.Fire:
• Accelerated writing of log data at the start of a firing program
• Corrected cyrillic font
• For one-stage or two-stage firing programs, cooling is preset to 500°C at a 75% lift position.
• The lift button must be pressed longer to fully open and close.
• The introductory video can be played in the "Help" menu item.
• Firing programs for LUMEX added.
• During pre-drying, the lift position is only displayed if the holding time is > 0.

In order to keep the updates clear, there is an applicable furnace update for every vPad update associated with the same software version number.

VITA recommends performing software updates in order to ensure smooth operation of your systems.

Should you have any questions or comments regarding the software updates, please call VITA Equipment servicing: 

Telephone number: +49 (7761) 562 222
email: instruments-service@vita-zahnfabrik.com.