Estados UnidosIt appears that you are currently in Estados Unidos.
Confirm
Select a different country

VITA VIONIC VIGO®

1
2
3
4
5
Chapter 4 of 5

Bonding of the VITA VIONIC VIGO denture teeth in the base

  • Check labeling to ensure correct tooth selection.
  • To avoid any contamination of the VITA VIONIC VIGO teeth, please wear talcum powder free examination gloves.
  • Please open the single blister pockets carefully to avoid teeth falling out.
  • The product tooth number is documented in the instructions for use.
  • Position all teeth one after the other in the cavities of the denture base to remove any occurring proximal interference.
  • One portion of glue supports two full dentures (1 upper & 1 lower)
  • Mix the two components using the applicator, bubble-free, for 30 seconds.
  • After that, immediately apply and process the bonding systems at room temperature (> 20 °C). Glue begins curing after 10 minutes.
  • Adhesive with a low viscosity may evaporate if it is handled for too long. To ensure that the adhesive surface is completely moistened, it is recommended to apply a generous amount.
  • To create a secure bond, the denture must rest without strain for at least 30 minutes after the teeth have been inserted.
  • Curing is finally complete after 20 minutes in the water bath of a pressure pot (55 °C, 2 bar). Alternatively, the curing can take place by storing the denture without strain for 12 hours at room temperature.
  • Any excess can be removed by careful blast polishing (1 – 2 bar) after bonding the teeth.
  • The mixing ratio of the two components is ideally matched to both of them and may not be changed.
  • If the low-viscosity consistency of the bonding system changes and threads begin to appear, for example, VITA VIONIC BOND can no longer be used.
Chapter 4 of 5
pt Portugiesisch