Instructions for use

Note:

• The VITA AKZENT Plus stain and glazing materials are available for characterization.
• Clean the pressed restorations with a steam jet prior to staining to remove grease or dirt residues.
• For information on the firing parameters, please refer to the Instructions for Use No. 10611 VITA AMBRIA (Version 4) in the chapter Firing for Veneering Technique under item 7.6 or No. 10636 VITA AMBRIA Press Parameters and Firing Programs (Version 003).

Please note:

• Restorations made of VITA AMBRIA and VITA LUMEX AC must be glazed with VITA AKZENT Plus GLAZE LT.
• Poor gloss will result if glaze material is applied too thinly. Avoid excessive application of glaze material and the formation of puddles.
• When using the glazing spray, spray the glaze on evenly from a distance of 10 to 15 cm while pressing the valve intermittently.
• The inner surfaces of the restoration must not be sprayed with the glazing spray.
• To increase strength, Power Glaze firing can be performed beforehand.
• Long-term cooling for wall thicknesses > 2.0 mm

Note:

• For information on bonding restorations made of VITA AMBRIA, please refer to the brochure #10146 (bonding recommendations).