Layering on Titanium

Note:

• For an optimal enamel application, reduce the DENTINE in the upper third.
• For a uniform level of moisture, the material should be carefully wetted with a brush in the interproximal areas from the palatal side before the enamel material is applied.
• To complete the crown shape, ENAMEL is applied in several small quantities.
• To compensate for firing shrinkage, the size of the mould should be prepared somewhat larger.
• Using a slightly moist separating knife, the individual bridge units are separated in the interproximal area down to the substructure prior to the first dentine firing.
• After removing the bridge from the model, complete the contact points with DENTINE and ENAMEL.
• Finally, the bridge is placed on a firing tray for the subsequent firing process.
• ENAMEL light is intended to achieve a translucent effect of the incisal edge. If a higher opacity is desired, TRANSLUCENT light-blonde, for example, can be used for lighter tooth shades, and TRANSLUCENT smoky-white for bleach shades.